| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859 |
- if ARCH_LPC32XX
- menu "Individual UART enable selections"
- config ARCH_LPC32XX_UART3_SELECT
- bool "Add support for standard UART3"
- help
- Adds support for standard UART 3 when the 8250 serial support
- is enabled.
- config ARCH_LPC32XX_UART4_SELECT
- bool "Add support for standard UART4"
- help
- Adds support for standard UART 4 when the 8250 serial support
- is enabled.
- config ARCH_LPC32XX_UART5_SELECT
- bool "Add support for standard UART5"
- default y
- help
- Adds support for standard UART 5 when the 8250 serial support
- is enabled.
- config ARCH_LPC32XX_UART6_SELECT
- bool "Add support for standard UART6"
- help
- Adds support for standard UART 6 when the 8250 serial support
- is enabled.
- endmenu
- menu "LPC32XX chip components"
- config ARCH_LPC32XX_IRAM_FOR_NET
- bool "Use IRAM for network buffers"
- default y
- help
- Say Y here to use the LPC internal fast IRAM (i.e. 256KB SRAM) as
- network buffer. If the total combined required buffer sizes is
- larger than the size of IRAM, then SDRAM will be used instead.
- This can be enabled safely if the IRAM is not intended for other
- uses.
- config ARCH_LPC32XX_MII_SUPPORT
- bool "Check to enable MII support or leave disabled for RMII support"
- help
- Say Y here to enable MII support, or N for RMII support. Regardless of
- which support is selected, the ethernet interface driver needs to be
- selected in the device driver networking section.
- The PHY3250 reference board uses RMII, so users of this board should
- say N.
- endmenu
- endif
|
