| 1234567891011121314151617181920 |
- #[gcode_button my_gcode_button]
- #pin:
- # The pin on which the button is connected. This parameter must be
- # provided.
- #analog_range:
- # Two comma separated resistances (in Ohms) specifying the minimum
- # and maximum resistance range for the button. If analog_range is
- # provided then the pin must be an analog capable pin. The default
- # is to use digital gpio for the button.
- #analog_pullup_resistor:
- # The pullup resistance (in Ohms) when analog_range is specified.
- # The default is 4700 ohms.
- #press_gcode:
- # A list of G-Code commands to execute when the button is pressed.
- # G-Code templates are supported. This parameter must be provided.
- #release_gcode:
- # A list of G-Code commands to execute when the button is released.
- # G-Code templates are supported. The default is to not run any
- # commands on a button release.
|
